電針
Electro-Acupuncture
操作方法 Manipulations
一般選取用側肢體1-3 對腧穴，毫針刺入腧穴得氣補瀉后，將電針器上的輸出電位器調到"0"值，把一對輸出導線分別連接在兩根針的針柄上，打開電源開關，選擇需要的波型和頻率，逐步調高輸出電流至所需的電流量，使病人出現能耐受的酸麻感。通電時間一般為10-20分鐘左右，針麻時間可更長。如刺激感減弱時，可適當加大刺激量，或斷電1-2分鐘后再通電，或改變頻率，以保持恒定的刺激作用。治療完畢，把電位器調至"0"值，關閉電源，撤去導線，起出毫針。醫學全在線www.med126.com
In general, 1 to 3 pair of points are selected from the same side of the body or limbs, puncture the point with the filiform needle after the needling sensation occurs and reinforcing or reducing needling manipulation is conducted, set the output potentionmeter of the stimulator to "0", connect the two wires of the output respectively to the handles of the two needles, switch on the power supply, select the desired wave pattern and frequency, gradually increase the output current until the patient gets a tolerable soreness and numbness sensation. The electro-stimulation may last 10-20 minutes. When used in the acupuncture analgesia, the stimulation may be longer. In case the stimulative sensation decreases, the current may be increased properly, or turn off the power supply for 1-2 minutes, then reswitch it on or adjust the output current to have a constant stimulative effect. When the treatment is over, turn the potential to "0" and switch off the stimulator, disconnect the wires from the needles and withdraw the needles.
